Author: zancat
Dumb Cross Member Question
I’m fabbing a fixture to hold the K member and trans for a from the bottom in installation, and I am in desperate need for a key piece of…
need min thickness for ’76 dart rotors (Disk brake conversion)
All,
Looking for min thickness on rotors off ’76 dart. Want to make sure all is well before I change the wheel bearing races. 🙂
Any help…
That 90° rubber vent tube on gas tank
So ours is broken / gone. What have folks done to find / make a new one?
I think the hose from my ’86 F150 (302) that went from my water pump to…
Looking for sources for heater control valve – 1967 B Body w/ AC
Title pretty much says it all. Looking for a heater control for ’67 GTX w/ air.
Seems like these are getting harder to find…..
Z
Funky Bracket on K Member ’67 GTX
So I’m cleaning up the K member on my wife’s car and notice this bracket cobbed on near the steering box. Any idea what it was used for? I can cut it…
WTB WTB 67 GTX (or similar) AC control buttons and lever knobs
Hello,
In need of some critical items to finish our dash. Need the buttons and lever knobs for AC / heat control switch (5 button vacuum switch),…
Engine / Trans Install – Up, or down?
Hello,
I have yet to rebuild the chassis on the ’67 GTX.
I am thinking of pulling the suspension and K member off the car, replacing it with a…