Author: synchro66

Does anyone know where i can source the 2 little nylon bushings for the base of the 727/904 auto floor change selector shaft?, as per attached pic. Thanks in advance

View attachment 1715588920

Has anyone on here had any experience with Aeroflow or the like, braided hose and fittings for their aircon? If so are the fittings reliable or do they leak. Like to know how reliable they are before spending the big $$ to do this. Cheers

I’m just in the process of installing larger Torsion bars to my A body. Just wondering if anyone can tell me the correct way to install them as per the factory service manual. Do i install without spindles attached, if so should LCA be fully down and just raise up till bar pops in; Do i install with spindles attached and use a trolley jack ? looking for the correct way to do it.
Cheers

I just bolted my oil pan back on after having it notched for a power steer conversion. Im having difficulty getting the inspection plate to its original position. Do the transmission bolts all need to be loosened and the trans moved back a 1/4" …

I am in the process of installing new cork side gaskets and rubber end seals in my LA 360. I have a couple questions. I notice that the cork gaskets protrude past the point where front and rear seals sit. Do they need to be trimmed to fit.? If not …

Have my 360 sb on a test stand after rebuild and it fires up and runs like clockwork, but when i look at the dissy cap the leads look quite messy. Any clues or fixes much appreciated

View attachment 1715340451

Just in the process of installing my new .920 Torsion Bars. Have them both fully inserted, but cant get them into the rear bracket deep enough to expose the circlip indentation ring so that I can install the wire circlips. Any thoughts??