Author: sportster2000
Inner cowl side hinge panel
Every so often I think about this and I have yet to figure it out. There is a square opening in the inner cowl side hinge panel at the bottom. It gets hidden by the kick panel.
Cowl picture Year One
What goes in that square cutout?
Pushrod Through Rocker Arm
What I am about to tell you all is second hand info about my car. Quick explanation is that my car live 120 miles away from me in my brothers garage. As payment he gets to drive it when ever he wants to. He sent me pictures which I will post below. The…
New 2010+ Challenger Seats
Has anyone attempted or installed any of the newer Challenger seats into their older cars? The reason I ask is I can get a set of 2010-2015 seats for $200. To rebuild the seats that I have in my 74 would cost me over 1K.
Rear Bumper Brackets 70-72 Challenger
I have a set of rear bumper brackets for a 70-72 Challenger. They are ADM reproductions. Never used. Brand new. Asking $75 shipped to your address.
Bumper Brackets | AMD 970-2570-S
Thanks,
Greg
Coil gone bad, again
The week before Mopar Nationals my coil went bad. Replaced it to find out that the alternator was bad as well. Replaced them and the voltage regulator. Now it appears that the new coil has gone bad, again. Any ideas as to what may be causing this?
74 Challenger
Hi all, been reading here a bit to find out info to help me on my way to get my car done. I bought the car 7 years ago (from a neighbor that had more projects than money) with hopes of getting it done in a year. Well that didn’t happen. Every time I looked at another part I found issues so I went ahead and pretty much went through the entire car so far and I still haven’t touched the interior. I have gotten to the little stuff to buy where I have no clue what I should be looking for, I’m…
Overdrive 833
The engine trans combo in my 74 challenger is not original. The trans came out of a mid to late 70’s truck per the numbers on the side. Brewers told me that in order to get the shift pattern correct that the 1-2? shift plate would have to be turned upside down and the linkage would have to be extended. Does anyone have any information on this such as length of the extension that has to be done on the rod or pictures of it?