Author: santts

Are these rubber steering coupler/Rag joints a big deal to change? If not wheres a good place to find one?. Thanks

Anybody every take out old belts out of long plastic receiver and replace with new? Seems to me you would have to remove male end? Was looking to just slide out and replace with my new lap belts I have . But not the case unless perhaps I get the heat …

Any idea where to get some with the 5/8s mounting holes on the belts? Alot seem to be half inch . My mounting bolts are 5/8 s. And retractable would be nice . The belts on this were with the long plastic sleeve with retractor at top of it They are real…

So I was cranking my 318 mopar in my 65 Fury and it just quit . Now I have a no start from the key. So I bypassed starter and started at the relay with a screwdriver and fired right up. I drove for an hr with no issues. Why the no key start? Starter…

Both tail light blinkers work with headlights off. The left tail light blinker will not when I turn lights on unless I pull out of socket . Ground ? Any ideas . Thanks

Figured I post again . Ignition control plug got very hot and was smoking . Then spark proceeded to go down ground wire towards alternator. I changed ignition module , checked continuity off ignition wires ( all fine). Checked resistor and voltage re…