Author: QuickBpBp

72-4 Cuda Barracuda Inner Original Grille Trim & RH Headlamp bezel

72-4 Barracuda/Cuda Original inner grille trim. Nice clean shiny pieces not all pitted. All studs good with 5 out of the 12 clips still attached. $95pr

72-4 Barracuda/Cuda Original RH Headlamp bezel. Chrome is nice. Could use the black repainted to be…

1970-4 Cuda Challenger Lower RH A/C Dash Trim

1970-74 Lower RH A/C Dash Trim. It is black and in very good condition with no cracks or previous repairs or paint work. It was laying in an open box and very dusty. I just wiped it off with water on the face surface so if someone wanted to paint them …

1970-4 Cuda & 71-4 Challenger Lower LH and RH Dash Trim

1970-4 and 71-4 Challenger Lower LH and RH Dash Trim.
All good condition with no cracks or broken screw stands. No repairs or previous paint work and not all scratched up. These were very Dusty from sitting in an open box. I just wiped them off with wa…

1970-74 Original Challenger Flip Top Gas Cap

Nice original 1970-74 Challenger Flip top gas cap. It is in very nice survivor condition. The chrome is not pitted and still has a good shine. Could use the black on the face repainted as it faded. The release latch works properly. Very hard to find or…

70-4 E-body Exterior Trim pieces

1970-4 E-body Vinyl Top A-Pillar trim. Excellent condition $70pr.

1970-4 E-body windshield trim corners. Good condition $50pr

Parts are located in SE PA.
Can send more pictures if interested.
Pm here on the board.
Thanks for free ad FEBO!

View a…

71-4 E-body A/C Vent Set

71-4 E-body Black A/C Vent set. These are a beautiful original match black set with no previous repairs. Stored for decades. The silver paint is original and still very presentable. The vents work as they should. The original black paint is excellent a…

1970 340 exhaust manifolds 2863553 & 2863549

Nice original 340 exhaust manifolds. Matched pair. Good condition with minimal pitting. They were blasted , painted and used then swapped out for headers. The heat riser is there but round part that mounts on the rod has been removed so that will need …