Author: Old School
500″ dyno results
i dynoed my 500″ motor today.re cap of the motor:
500″ 4.380-4.150
13.1-1 cr
indy cnc sr,s flowed 367@.700″ (367@.700)
comp solid roller…
318 to 360 motor mounts
O.K. Guys
I’m sure this has been asked before but I can’t find it in the forum anywhere. I am removing a 318 from a 1974 duster and installing a 360. Will the motor mounts off of the 318 fit the 360 or will I have to purchase new mounts. It is going to have a 727 behind it. Will everything else fit? I’m going to use the intake,starter, and exhaust manifolds,distrubitor, water pump ect off of the 318.
Any other suggestions would be appreciated.
…
Valvespring tester?
looking for a good bench mount valvespring tester.needs to go to at least 900lbs. what do you guys use?
also how about a good on engine valvespring…
smiley replys
how do i get more of the smiley guys for my replys? now i only have about 12 of them.i’ve had theese for a long time.need some new ones,thanks
Replacement for 1000h springs
what would be a “better” replacement valve spring for my k motion 1000h,s ?this is in a street car.i have heard the 1000h,s are too brittle for…
360 torque converter question
Hi guys
I’m new to this site so if I don’t follow proceedure correct me.
I have a built 1978 360 truck engine that is assembeled and ready to go in my 74 duster. I’m removing a 318 that has a 727 transmission in it. The 318 and trans are 1976 out of a camper.The Question is. Can I resuse my 318 torque converter? I purchased a 360 flexplate but from what I read the 360 uses an external balanced torque converter. I’ve read in a couple of magazines where you can use a 360 converter with a…
Northwest Newbie
I just wanted to say hi and that I’m glad I found this site. As the rainy season has arrived, I’ll be working on my 67 Belvedere and I’m sure I’ll…