Author: Moose440

Hey guys is there an aftermarket axel that will fit 8-3/4 rear on a 68 Newport. Something stronger then stock???

I know this has been all said lol. But any advice will help. I have a 440 .040 over with forged pistons 440 source heads 2.14 intake 1.810 exhaust. My cam is a comp 564int/564exh duration 295in/307ex 110 lobe sep. it has matching springs and all that i…

Hey guys I’m sure you have herd this a million times so please bear with me. im in between a power master 95amp a tuff stuff 100amp and the very beautiful looking mopar performance 110amp alternators. They all are one wire there all around the same pri…

Trying to trade my dual 500cfm eddy set up with performer manifold for single 850 Holley with manifold. Located 11776.

View attachment 1090613

View attachment 1090614

View attachment 1090615

Hey guys I’m looking to trade or sell my dual 500cfm edlebrok set up with performer intake it’s on a 440. for a single 850 holley with intake. The work fine there on my motor now so can demo that they work fine.located in port Jefferson new york

Vi…

I have a 68 Newport with a 440 .030 over 440 source heads crane rockers and cam. I had the motor redone in April and I herd a lifter tick. When I pulled the valley pan I noticed my cam was not riding on the center of the lobes and you can move the cam …

Hey guys I’m replacing my cam in my 68 Newport and would like to know what is the biggest cam you can fit with flat top pistons?? specs are 440 stock bottom end .30 over with 440 source aluminum heads 2.14 intake 1.810 exhaust 3/8th pushrods with hy…