Author: KJoeZ61

My right arm isn’t what it once was, going back to PS. The reservoir was leaking pretty bad before and the way the outside of it was beat up I can see why. Anyway I cleaned it up and smoothed out the metal on the lip. My concern is should the inside be painted? I think not, but I’m not sure. However it looked like it was, but it all came off with the Simple Green, didn’t on the outside though!

View attachment 1715207729

I’m sure this has been asked before but I cant find it. The attached picture shows my linkage as it rests. My question is the lever on the transmission can travel about a half inch more at full throttle, but wont as it’s adjusted. So should I adjust it more that the lever on trans is more engaged at rest?

View attachment 1715204062

I have a stock 4 door 66 Monaco that I installed a 4 BBl intake and carb on several years ago but didn’t swap the camshaft. The engine runs great however its got a few oil leaks and the freeze out plugs need to be replaced so I’m pulling the motor this spring because its time to address these issues. Could anyone recommend a good camshaft & lifter kit to put in? Also planning on replacing the timing chain as well.

The cars exterior and interior were fully redone a few years ago, its a…

1966 Monaco 4 BBl conversion ( Camshaft ?)

Very nice condition 4 door hard top Dodge Monaco. Strong 383 with 4 Barrel carburetor and dual exhaust. Runs and drives great, was repainted and interior was replaced 4 years ago, always garage kept….

1966 Dodge Monaco

Nice car and very dependable, I purchased it about 10 years ago. Time to move on!

I have a stock 4 door 66 Monaco that I installed a 4 BBl intake and carb on several years ago but didn’t swap the camshaft. The engine runs great however its got a few oil leaks and the freeze out…

So yesterday, Christmas Eve it was 73 degrees outside here in eastern Pennsylvania. I decided to pull my 1966 Dodge Monaco out of the garage for a run. Looks like another freeze plug may be leaking,…