Author: JimmyG

Hi there. I am looking for a clutch rod boot/seal 61 Newport 3 spd A745 manual trans. No part numbers are in my 61 parts book, but the 60 parts are listed as drawing 6-50-10 Boot #1731 232, 6-50-11 Seal, boot #1731 234, 6-50-12 Reinforcement, boot…

Hi there. I am looking for a rebuild kit or seals kit for a 1961 Chrysler Newport standard steering non-power gearbox. Any suggestions?

Hello. I am looking for the photo attached type of wiring clips. They are one piece, have two 1.25" arms, rubber coated for most of their arm length, have a 5/16 hole in the centre for attaching to the firewall with a screw and have a .75" fl…

I am looking for these wiring clips. They screw on to the firewall. Looked in the usual suppliers, but no luck. The arms are approx 1.25", the flat spot in the middle is approx .75", and the screw hole is approx 5/16ths, each arm is rubber di…

Hello. I scored a complete front 61 Chrysler New Yorker Sway bar including all pieces, brackets, mounts, rods, nuts, bolts and rubbers. Both retainers/links/shafts (run from the bar to the body mount bracket) are a small shaft and corresponding nut. Bo…

Has anyone found a rear sway bar kit for a 61 Newport or have a workable suggestion for a donor vehicle or year? Thanks

I am seeking the interior arm rest and side panels (both sides) that cover the inside wheel tubs, in the rear interior of 60-62 Chrysler 300, 2dr, with buckets. I look forward to hearing from you. Jim.