Author: doubleyellow

Console Door Lock Differences

Restoring my 1970 center console. Have two doors. One on left is dated 11/69. One on right is dated 4/70.

Didn’t realize that they may have used 2 different locks.

Questions: Are they both correct? One or the other correct? or neither correct?

Thanks

Booster – Piece of Valve Fell in

Cheap aftermarket plastic valve (intake hose) broke off at the booster. Half of the valve fell into the booster.

Please let me know if this will damage the inner diaphragm, or will be harmless? Need to decide if I have to remove the booster and get th…

Rim Blow vs. Standard Wheel

Have manual steering and my 50 year old worn down standard steering wheel. Really difficult to turn, and the worn down plastic wood wheel is really slick.

Is the optional Rim Blow rim any larger in diameter for better grip? Is the grip better in gener…

Compression and Spark Plug Diagnosis Help

1970 440, stock, fully rebuilt, couple hundred miles since going in the Challenger.

So been chasing a vibration/roughness issue. Idle is OK, but over 200 RPM, engine get progressively worse in regards vibration/roughness.

Checked timing, dwell, plug…

Heater Motor not Running – Ground Question

Heater Blower Motor not running. Going to start by checking ground. Non A/C

Where exactly is the factory ground for the blower motor? Is it the engine side firewall? The 3 nuts need clean ground (no paint) to the firewall? or is the ground somewhere u…

Rallye Fuel Gauge Troubleshooting

Fuel Gauged pegged to Low side. When ignition "on" gauge needle moves very slightly up, but very, very little. Checked Ohms on Sending Unit (between sending unit post and ground) and reads about 25 Ohms. I believe that means there should be s…

Door Panel – type of plastic and best adhesive

Are the interior door panels Polypropylene? or other plastic type?

Best adhesive you have found to repair door panel cracks?

Thanks