Author: Camshaft

Hey all. Been looking all over the place for these type of straps. 67 Chrysler 300. About 3 inches or 3 1/4" long with the snap buttons both on one side. All the ones I find are one snap button on each side. Any help?
As usual , much appreciated….

All: finalizing some wiring issues and attempting to mount the fender top turn signals. I have the wiring with the triangular amber lenses, and the chrome top, but it seems like there should be a small plate that goes on the inside of the fender to hol…

All: Right down to the final push on my 67 300 drop top and my pal (who has been a great source of knowledge and assistance) knocked my Right front clear turn signal off the bench onto concrete floor. Needless to say, it did not survive! I have put bac…

Question #1 – Getting close to the end on finishing the 67 300 drop top. As some of you know from my past posts, had an engine compartment fire many years ago, burnt right thru the firewall. In my unpacking of the many totes full of stuff in my garage,…

All: Anyone know of a manufacturer who replicates these clips and fasteners? Been searching through a lot of sites to no avail. Any help appreciated. The clip is 1 " long, and the stud is 1/2" high. Cam (shaft)

View attachment 466627

…

All: Looking for just one Road Wheel Center cap with the short wide volcano center. Unfortunately, one of mine was just damaged badly and is not repairable. Anyone hoarding one out there? Does not have be perfect, maybe a 6-7 out of 10. Appreciate any …

All: Looking for one or a couple of these guys. 1967 Chrysler 300 drop top, 1980 Cordoba discs in front. Looked all over, no photos in most ads so hard to see which one is correct. Any assistance would be much appreciated.

Cam (shaft)

View attachm…