Author: Blucuda413
Small Block Mopar Milodon Gear Drive
Excellent condition. $350 plus shipping. Paypal or Postal Money Order. Alexandria, Louisiana.
W2 Street Dominator Intake
Excellent condition. Only mods is polished years ago and rear of manifold drilled to bring water from rear of head to water manifold. For those who don’t know: The plenum and runners are exactly the same as in the Strip Dominator. $350 plus shippin…
Big Inch Smallblock
What is your experience in using a 4.250 crank in a smallblock. I’m sure clearancing at bottom of cylinder would be required but is there anything else?
Webers on a blower??
Anyone have any experience using 4 Weber 48IDA carbs on a 6/8-71? I’ve just procured a complete setup for a blower. Unit has been sitting for years and since I have zero experience with these carbs I’m asking input from those with experience. Unit has manifold to blower, 4 48IDA carbs (Italy), fuel line plumbed and all linkage. How should I proceed from the start. Unit will be installed on a 413ci SBM setup with a 6-71. Suggestions appreciated!!
Head gasket bore diameter vs block bore diameter??
My block is bored to 4.100 and many gaskets are either 4.125 or 4.180. Which is best for a compression of 13:1 and either .050 or .060 thickness??
Warranty Block?
How to tell if block is warranty block? I have a 340 block with no numbers on drivers side along pan rail. It does have numbers stamped in front below drivers side head. I can’t read them but they look like they are double stamped. Also stamped is the dreaded horizontal diamond. Is this a warranty?
R5P7, Any Interest??
Looking for 2 people INTERESTED in purchasing a used freshened NASCAR R5P7 engine. Have contact with guy with three, 358ci, fully dressed except exhaust and carb. They are 830hp with 0 laps, 832hp with 0 laps and 837hp with 20 laps. Would love to make deal on purchasing all 3 but can’t do it without help. Currently asking $23k for all but I think will go lower (will have to). PM me if seriously interested. Thanks, Max