Author: Binky1945
An ignition/starting issue on my 1973 Plymouth Fury automatic
Hello, I am Jim Dent. I haven’t been on here for quite some time but I find myself needing learned assistance on an ignition/starting issue on my 1973 Plymouth Fury. I cannot get the motor to start. It turns over just fine but the electrical conne…
Tied up in spaghettiland!
1973 Plymouth Fury 2, 440, four door sedan. Looks like it takes a # SMP24529DG headlight wiring harness for a # Q628TY replacement headlight switch.
Regardless of whether these numbers are correct to your files lets say that I do believe them to be co…
I need a fresh air vent for a ’73 fury
i need a good used (right) passenger side fresh air door vent cable handle ass’y. It is about 1.5′ in length and actuates a metal air cone thingee used to bring fresh air into the cabin from the passenger side thru the heat/cold levers using a vacuum…
Mopar A/C Shutoff Switch Dashboard Decal
I have had a dozen of these made up. It was factory placed on the dashboard of the 73 Fury 2 police car we are rebuilding. I don’t know how many different years and models it was installed in. If you would like one please send $15.00 to my PayPal acct and send your mailing address to me at E mail address removed by staff Thank you, Jim Dent
Original 1973 Plymouth Fury radio antenna … New or Good used
Hello, does anyone out there have a complete original fender radio antenna ass’y for a 73 Fury for sale at a good price? Would prefer a good used straight three section if available. Don’t think I can afford a nos one but you can quote me. Thank you Jim Dent (seagraves26@aol.com or 859 575.4444 in Ky.)
73 Fury 3 heating and cooling parts
Hello again, Does anyone have a mopar parts number for the cork gasket that embeds in the flat side of the heater core support frame? It is about 20″ long by 10″ wide and about 3/16″ thick. I see images of it in the Mopar chassis blue book but I cannot find a parts number. Also looking for the original film tape seals that stick onto the a/c/ evaporator mount’s flat side. Considering using stick foam insulation tape but would rather find some original parts. Old cork gasket is still in…
Used 1973 Plymouth Fury 2 Front Bumper License Plate bracket
Looking for a used but in good condition front bumper license plate holder and the finger grab (winder button) that goes on the factory dashboard clock stem. Thank you, Jim Dent