Author: 66cornet

Just a quick question….

I have a 74 Dart Sport and am in need of fenders…can I use fenders from a Dart “Swinger”?

Just wondering if anyone has any pointers and or comments about my next project…tubbing my 66 Coronet!

This own’t be a “spring move” it will entail the whole she-bang!

Thinking about ordering a Comp Engineering kit, fully welded and going from there.:dude:

Pulled another 440 from a motor home and wondering what type of info anyoine had for me?

#’s on side of block are 3698830 440 9
tranny looks like a 727 but has a trans brake or something attached to the back almost resmbling a mini torque convertor…

Once again, I am looking for some info from you guys out there that have had any good luck with a particular “race” plug for my 440…well actually 538

I’ve looked into NGKr’s and also Autolite has a race plug. I wonder if anyone has tried those E3 plugs???

Looking for part’s and positive…

I’m building a street/strip big block and need some help.

I’ve eliminated my mechanical water pump and gone electric, no power steering or any other pulleys…just crank and alternator.

My question is this: what can I pull a “smaller” pulley from to drive my alternator? I don’t want to buy an…

Some I’m almost done putting together the ’66 and along comes this ’36 Dodge four door sedan that’s just frame rails, a rear end, and a body with doors.
I have most of the parts to make it run(i’m pretty mechanically inclined) but need to do the suspension…IS IT THAT TOUGH TO DO?
the rear is leaf…

Hello to all. Just joined. I’m from Ohio. My ride is a 1966 Dodge Coronet 440. I have transplanted the 318 pooly with a 440, .030, eagle h-beam rods,…