Author: 440beep

Has anyone used the Eastwood HD Anti-rust spray paint, and if so, how long until dry. Can says 2-4 days, and the website says it’s an oily/waxy spray, so curious if it will finely dry/cure. Sprayed my LCAs two days ago and still very tacky. Hope it …

With the front end being apart on my 69 Bee, front disk brake car, I discovered this oddity with the caliper bracket, looks like the mounting holes have been torched open to make bigger.

Any body have ideas or know where I can get just these bracket…

Got one LCA off and starting other side today. But a few questions.

Looking at the pivot arms, mine look pretty good and should be better once cleaned up, but comparing the originals to an aftermarket pair I noticed some slight differences. curious i…

I have the oil pan off my motor to fix a RMS leak, and I am so tired of the oil pan not holding a layer of paint and looking like crap. Perhaps the paintwork prep was crap as there is no primer on it, just VHT hemi orange on a Moroso pan. The Moroso …

In this picture, where the yellow arrow is pointing, is this torn up rubber gasket/seal replaceable? Been looking through the FSM and Factory Parts Catalog, and can’t find anything specific on it, though in the Parts Catalog, it looks like it may be r…

My black Super Bee has a white stripe, and it’s ok, but I’m really keen to remove and replace with a red stripe. From the factory, the car was B5 blue with a black stripe, but when it was restored by someone else, it was painted black; so I’m pretty much free to do whatever stripe I want now. The white just looks kind of boring compared to a red stripe.

Anyways, other than using my 3M removal wheel, is there a quicker way to remove the stripe?

View attachment 1223207

1968 radio am/ 8 track player. Radio is out of a 1968 Charger. Complete setup: radio, wiring harness, dash plates, two small speakers. $1,000. OBO. PM with any questions. Located in NW Indiana.

View attachment 1206834

View attachment 1…