Need some help here guys. This Old Fart is frustrated and the patience thing is at the lowest level. Putting some TTI headers in and have the drivers side in but not bolted in yet. There is no tranny installed yet. Have raised the motor about 3 to 4 inches to give me some room, but the torsion bar seems to be in the way. Some of the bends in the headers are just a little large to get it in and down. How do I remove and re-install a passenger side torsion bar which is the obstacle. The books I do have don't tell me a whole lot. I'm doing this in my drive-way so there is no hoist guys. The car is a 70 Dart Swinger. Give me some ideas please.