Have a new roller cam that was in a 1989 rebuilt 360 I purchased. No idea what the specs are....pretty sure it's stock.
I came up with about .422 lift by doing this formula:
Measure cam lobe height then width. Subtract width from height and then multiply by rocker ratio....don't even know if this formula is correct...found it online.
1.630 -
1.366 = .264 X 1.6 = .422
Anyway....it has never been run and I can't find any numbers on it.
$50 plus shipping.....
Thanks!
Brian
milltrade@cox.net
I came up with about .422 lift by doing this formula:
Measure cam lobe height then width. Subtract width from height and then multiply by rocker ratio....don't even know if this formula is correct...found it online.
1.630 -
1.366 = .264 X 1.6 = .422
Anyway....it has never been run and I can't find any numbers on it.
$50 plus shipping.....
Thanks!
Brian
milltrade@cox.net