So, I have a short block 360 that is a 1989 block. So it can run a roller cam.
I have been getting tons of good advice from folks here about flat tappet cams cuz that what I was going to go with.
But if I decided to go roller, what would be a good performing cam for this setup? And are there any low cost decent ones available?
360 bored .030 over
Stock Pistons..they are about .100 in the hole
1994ish Magnum heads
Edelbrock Air Gap intake or Cross Wind
Carter AFB 625 (can be changed if need be)
Exhaust manifolds into dual exhaust
I had settled on my flat tappet cam and was going to go with a Lunati 60401...but I'm only gonna get one shot at this and the roller cam/lifters is appealing.
Thanks to all!
Brian
I have been getting tons of good advice from folks here about flat tappet cams cuz that what I was going to go with.
But if I decided to go roller, what would be a good performing cam for this setup? And are there any low cost decent ones available?
360 bored .030 over
Stock Pistons..they are about .100 in the hole
1994ish Magnum heads
Edelbrock Air Gap intake or Cross Wind
Carter AFB 625 (can be changed if need be)
Exhaust manifolds into dual exhaust
I had settled on my flat tappet cam and was going to go with a Lunati 60401...but I'm only gonna get one shot at this and the roller cam/lifters is appealing.
Thanks to all!
Brian
