Author: shadango
Hot hump
I was driving with my son in the 80 Volare yesterday….nice evening drive……after about 10-15 minutes I realized that my left leg was hot…..
We took the carpet out a while back to look for the water leak…..and havent put it back in yet (havent figured out the leak)….
The tranny hump is HOT — as in touch it for more than a second or two and it BURNS ya.
My Cuda’s hump gets hot , and that is with carpet…..so maybe its the same …but DANG.
Gonna put some of that hushmat on it…
Figuring out rear axle ratio…what the……
So on my Cuda, when I got it, I wanted to know what the rear axle ratio was…..I marked the rear wheel on the inside surface and a corresponding mark on the backing plate…..then a mark on the shaft yoke and a corresponding mark on the lump.
Rotated…
Will 15×7 rally rims fit an 80 volare?
Wondering if 15×7 chrysler big bolt rally rims will fit a 1980 volare??? Would they be the same as the chryslre corporate steel rims???
Source for horns
The two horns on our 80 Volare are apparantly rotted internally. They will make a noise but very muted and croaky sounding.
Figured it was just out of adjustment, bad ground etc……but looked at all that and no change.
There rust bubbling around t…
A/C questions and ramblings
Have no immediate plans to get the A/C in our 80 Volare going…..I figure the kiddo can muddle through with no A/C just like his Dad has to inb the Barracuda…LOL….let him develop an appreciation for it.
That said, I am just sitting here ponderi…
Cracked windshield
Dangit….
Got home and the small chip on our 80 Volare windshield has trned into a foot long crack due to the warm weather getting frigid over night (I assume)….about a foot long crack now, 6 inches on either side of the chip.
(insert pulling my hair out thread here)
So…..PLEASE tell me that windshields are not ridiculously hard to find/expensive……
One positive here…..it already had a small 1/8″ crack in one corner, probably a sloppy install job on the aftermarket glass in…
F body A/C, slant-6 — pull intake/exhaust question
Anyone with an F body, slant 6 A/C car know if its possible to yank the intake/exhaust manifolds without ALSO pulling the A/C & air pump, steering pump etc?
Have to change our intake/exhaust gasket and trying to not have to rip the entire engine d…