Author: quapman

I recently bought a 74 Gold Duster…Light Gold with a wacky Snakeskin 1/2 Vinyl top. Anybody else here have one? What are your paint & top codes??

Is this at all rare?

Does anyone have production #’s for 74’s at all? Gaylen is no help as usual.

Thanks!

Need a set of front bumper brackets for 70-72 cuda/Barracuda. $162 for new ones just seems like a lot. Thanks.

Once again, I’ve bitten off more than I can chew and have to sell off one of the projects.

It’s a 73 Challenger, A57 Rallye, G code 318 car. HB1 Blue w/ blue bucket interior, auto, console, NO A/C, 904, 8-3/4 rear.

Car has some rust, but pretty clean for a 43 year old car with original paint. Cowl and lower a-pillars will need attention. Trunk floor is mostly cut out, but new 2-piece AMD panels are included. Floors are nice except driver’s side front, which is crusty. Frame rails are…

73 Rallye Challenger in NC

I’m looking to sell a few things to a European customer and have no idea what things go for these days. What are the following worth?

3.23:1 sure-grip center section-489 case (known good, used)
Rear window plug for Challenger S.E. (Just the fiberglass, no glass, no trim)
Used 70/72 Challenger front bumper brackets
E body rear sway bar w/ brackets
S.E./Gran Coupe upper console with wiring (No headliner)

Thanks

I’m installing a FPAP rear AAR spoiler on my 73 and could use some pictures and/or measurements for a proper install. The left/right alignment is obvious, but front/rear is another story. I plan to make a paper or cardboard template, so I don’t F it up completely.

Thanks

This one started as a slant six, three speed on the floor, Burnt orange inside & out. Now has a non-running 318/904 and 8-3/4 rear. WYSIWYG minus…

73 Cuda parts car. Was a 340 car, no motor/trans now. WYSIWYG. Lots of good parts left including the broadcast sheet! Wheels NOT included.
…