Author: MJFUR

I have a 69 Chrysler 300 with A/C. Heat, DEF, A/C, MAX A/C all work correctly. The only problem is that when running the A/C some of the condensation/water leaks out of the rear housing and into the car. I usually just throw a towel under it to absorb …

Looking for a set of Bolt/Swivels for a 69 Chrylser 300, part # 2525087. Chrysler & Dodge are the same, Plymouth is different.

Thx,
Mike

69 Chrysler 300, re-installing the swivel bolt with car jacked up. Got about three quarters back in and blamo the bolt shoots back out. It stripped the threads from the bolt shaft. You can spin the threads like a washer on the shaft.

Where do I get ne…

69 Chrysler 300, re-installing the swivel bolt with car jacked up. Got about three quarters back in and blamo the bolt shoots back out. It stripped the threads from the bolt shaft. You can spin the threads like a washer on the shaft.

Is 2525 087 still…

69 Chrysler 300, headlights are dim, going to replace. If what I have are still original bulbs I’ll save them. I can post pics if needed.

Low Beams marked – General Electric, Sealed Beam, 2
High Beams marked – Wagner Halogen, 1C1 or ICI (I presume the…

69 Chrysler 300 with new fuel tank, fuel lines, rubber hoses, vent tubes cleaned with brake cleaner, pipe cleaners and compressed air to verify positive air flow.

The car has been up and running a little over a year now. Recently I’ve noticed that aft…

What is happening here?

69 Chrysler 300, the rear end has been rebuilt 4 times in the last 3000 miles. 8 3/4 Diff Dilemma

I saw some leakage on the backside of the Rear Drivers Side tire, figured it was the brake cylinder. When I took it apart, it s…