Author: az426hemi

I need them for the Small Bolt Pattern for my Duster.

Thanks,
Mike

I need them for the Small Bolt Pattern for my Duster.

Thanks,
Mike

I have a fresh 383 going in my 64 Dart. The engine has about 10.5 comp with 440 Source heads that have been blueprinted and stage 1 ported by Muscle Motors. I have an RPM intake with a Biggs 750 carb. The car has a 4.88 Dana with a hemi 4 speed using 30″ tall tires.

My question is mainiy to those who have actually run that cam in a 383.

1. How was the power output?
2. What was the power band

While I am mainly interested in the .557 cam I know that there are probably better cams…

53 3/8″ is the flange to flange bare housing width. Does anyone know what this is out of?

I need stock axles for it if I can figure out what…

I am thinking of putting 17″ wheels on my Duster. Can anyone who has put these on their Duster or Demon post some pics?

What size width and offsets did you use on the front and the badc.

What size tires did you use?

Did you minitub or is the car stock?

Please post pics if you can.

I am thinking of putting 17″ wheels on my Duster. Can anyone who has put these on their Duster or Demon post some pics?

What size width and offsets did you use on the front and the badc.

What size tires did you use?

Did you minitub or is the car stock?

Please post pics if you can.

He Haw.