318/360 magnum issues

!!! So I'm on my last nerve with this engine,
it's a 318 block 360 magnum heads,
I blew a head gasket car overheated changed them both, a few houndred miles later blew the other head gasket, not completley just had oil seeping out where it mates with the head, changed them both again doing everything right torqueing them to 100 ft lbs and I'm out driving today less then 100 miles since the new gaskets and oil is seeping out the passenger side head gasket ....

It has a large cam hydraulic lifters it doesnt over heat, it runs about 170 and in traffic was creeping to 190, i had the heads checked and surfaced there are a few passages on the block that were plugged i guess to acomedate the magnum heads...

anyone have any ideas? anything I should check to make sure that mysetup is working? i'm about ready to dump this setup and find a running 360 and just drop that in...


thanks !

Chris
Author: admin